Draw-tite 75766 MAX-FRAME RECEIVER User Manual download pdf

1. Remove tie down bracket from the driver’s side of the vehicle and return to vehicle owner.

2. Lower exhaust. Remove or reposition exhaust rod. If removed, return to customer. If repositioned, remove bolts, rotate rod to

point forward and reinstall bolts.

3. Raise hitch into position over existing weldnuts and install the M12 bolts and conical toothed washers as shown above.

4. Raise and attach exhaust.

Installation Instructions

Toyota RAV4

Part Numbers:

44686

75766

87631

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 12 mm, 17mm, 19mm

Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft.

z 2012 Cequent Performance Products, Inc. – Printed in Mexico

Sheet 1 of 3 75766N 11-20-12 Rev. A

Qty. (4) M12 X 1.25 X 40mm CL10.9

Qty. (4) ½” Conical Toothed Washer

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 75766F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

5000 (2267 Kg) 525 (238 Kg)

Weight Carrying

Ball Mount

3500 (1589 Kg) 525 (238 Kg)

Wiring Access Location: SUV3, SUV4

Fascia

Drill Bits: None

Frame Rail

Accessory Rating

Remove both M8 fasteners

Exhaust Rod

Muffler

1 2 3

Summary of Contents

Page 1 - Installation Instructions

1. Remove tie down bracket from the driver’s side of the vehicle and return to vehicle owner. 2. Lower exhaust. Remove or reposition exhaust rod. If r

Page 2 - Instructions d’installation

1. Enlever les supports d’arrimage du côté conducteur et les retourner au propriétaire du véhicule. 2. Abaisser l 'échappement. Enlever ou reposi

Page 3 - Instrucciones de instalación

Instrucciones de instalación Toyota RAV4 Números de partes: El enganche se muestra en la posición correcta Equipo necesario: Llaves: 12mm, 17mm, 19mm