Draw-tite 75772 MAX-FRAME RECEIVER User Manual download pdf (Page 1)

1. Lower and remove spare tire from vehicle. The tire release is located underneath the storage compartment in the back of the vehicle.

2. Remove the driver side rear plastic cover, located underneath the vehicle, by using a #2 Phillips head screwdriver to remove fasteners, also remove

(4) plastic push pins. Then remove the passenger side rear plastic cover, located underneath the vehicle, by removing fasteners, and (3) plastic push

pins (Do not discard items).

3. Lower exhaust by removing the rear and side hangers.

4. Raise hitch into position and insert M12 bolts through the bracket and frame as shown in Figure 1. Note: The bumper locator pin may interfere

with the hitch hardware. If necessary, use an angle grinder to trim the locator pin at the shoulder to allow proper hardware clearance.

5. Insert M10 bolts through bracket and into the frame as shown in Figure 1 (Hand tighten).

6. Torque M10 bolts first and then M12 bolts to the specifications below.

7. Reinstall exhaust hangers into mounts.

8. Trim rear plastic covers as shown in Figure 2, then raise into position, reinstall the fasteners and push pins that were removed in Step 2.

9. Reinstall spare tire and make sure it is seated properly.

Installation Instructions

Kia Sorento

Hyundai Santa Fe Sport (5 Passenger)

Part Numbers:

75772

44689

87634

Hitch Shown In Proper Position

Equipment Required: #2 Phillips Screwdriver

Wrenches: 17mm, 19mm

Drill Bits: None

z 2013 Cequent Performance Products, Inc.

Sheet 1 of 3 75772N 4-24-13 Rev. B

Qty. (4) M12 x 1.75 x 120 Bolt CL8.8

Qty. (4) M10 x 1.25 x 30 Bolt CL10.9

Qty. (8) 1/2” Conical Washer

Qty. (4) 7/16” Conical Washer

Qty. (4) M12 x 1.75 Nut CL10

Qty. (1) Spacer Plate

Tighten all M12 CL8.8 fasteners with torque wrench to 72 Lb.-Ft. (98 N*M)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 75772F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

5250 Lb (2381 Kg) 525 Lb (238 Kg)

Weight Carrying

Ball Mount

3500 Lb (1587 Kg) 525 Lb (238 Kg)

Wiring Access Location: SUV1, SUV2

Fascia

Fasteners typical both sides

Frame rail

2 Existing Weld Nuts

(Typical)

Spacer Plate

CONSULT WITH VEHICLE OWNER BEFORE CUTTING REAR PLASTIC COVERS

Tighten all M10 CL10.9 fasteners with torque wrench to 40 Lb.-Ft. (54 N*M)

jkkl

Figure 1

Figure 2

Cut Down at Radius

2”

Form: F205 Rev C 9-17-2012

Accessory Rating

1 2 3

Summary of Contents

Page 1 - Installation Instructions

1. Lower and remove spare tire from vehicle. The tire release is located underneath the storage compartment in the back of the vehicle. 2. Remove the

Page 2 - Instructions d’installation

1. Abaisser et enlever le pneu de secours. Le déverrouillage du pneu est situé sous le compartiment à bagages à l'arrière du véhicule. 2. Enlever

Page 3 - Instrucciones de instalación

1. Baje y quite la llanta de repuesto del vehículo. El liberador de la llanta se encuentra debajo del compartimiento de almacenamiento en la parte tra

Comments to this Manuals

No comments

Draw-tite 75772 MAX-FRAME RECEIVER User Manual Page 1

Browse online or download User Manual for For the car Draw-tite 75772 MAX-FRAME RECEIVER. Draw-Tite 75772 MAX-FRAME RECEIVER User Manual

Summary of Contents

Comments to this Manuals

Draw-tite 75772 MAX-FRAME RECEIVER User Manual Page 1

Browse online or download User Manual for For the car Draw-tite 75772 MAX-FRAME RECEIVER. Draw-Tite 75772 MAX-FRAME RECEIVER User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Draw-tite 75772 MAX-FRAME RECEIVER