Draw-tite 75547 MAX-FRAME RECEIVER User Manual download pdf

Installation Instructions

Honda CR-V

Part Numbers:

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 17mm, 11/16

Drill Bits: None

Existing

weldnuts

typical

z 2007, 2011 Cequent Performance Products

Sheet 1 of 3 75547N 6-21-11 Rev. B

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 75547F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Wiring Access Location:

Form: F205 Rev A 5-6-05

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

Not For Use With Spring Bars

Weight Carrying

Ball Mount

3500 (1589 Kg) 525 (238 Kg)

75547

87440

44575

Tighten all 3/8-16 GR5 fasteners with torque wrench to 30 Lb.-Ft. (41 N*M)

Tighten all M10 CL8.8 fasteners with torque wrench to 38 Lb.-Ft. (52 N*M)

1. Lower exhaust by removing rubber isolators from muffler hangers. Remove the outside isolator first then the inside isolator.

Spraying a lubricant or soapy water on the metal hanger rod and the rubber isolator helps removal.

2. Raise hitch into position.

3. Install M10 fasteners as shown.

4. Install the 3/8 U-Bolt through the vehicle tie down hook and through the tie down hook attachment of the receiver. Install flat

washer, lock washers and 3/8 hex nuts as shown above.

5. Tighten all fasteners to the required torque specification.

6. Raise exhaust back into position and re-install rubber isolators.

Inside isolator

Note:

Fasteners typical both sides

Exhaust shown lower

Tie

down

hook

Qty. (4) Hex Bolt M10X1.25X30 CL8.8

Qty. (2) Flat Washer

Qty. (4) Conical Washers

Qty. (2) Lock Washer

Qty. (1) 3/8-16 U-Bolt

Qty. (2) 3/8 Hex Nut

Fascia

Frame rail

1 2 3

Summary of Contents

Page 1 - Installation Instructions

Installation InstructionsHonda CR-VPart Numbers:Hitch Shown In Proper PositionEquipment Required:Wrenches: 17mm, 11/16Drill Bits: NoneExisting weldnut

Page 2 - Instructions d’installation

Instructions d’installationHonda CR-VNuméros de pièces :Attelage montré dans la position appropriéeÉquipement requis :Clés : 17 mm, 11/16Mèches : Aucu

Page 3 - Instrucciones de instalación

Instrucciones de instalaciónHonda CR-VNúmeros de partes:El enganche se muestra en la posición correcta Equipo necesario:Llaves: 17mm, 11/16Brocas de