Draw-tite 65057 FRONT MOUNT RECEIVER User Manual download pdf

Front Mounted Receiver

Installation Instructions

Dodge 2500 4x4 Models

Part Numbers:

65057

Hitch Shown In Proper Position

Equipment Required: Bolt leader (Provided)

Wrenches: 18MM DEEP WELL, 7/8”

Drill Bits: NONE

Other Tools: Tape, Cutting tool for hard

Plastic fascia.

Tighten all 18mm fasteners with torque wrench to 92 Lb.-Ft.

z 2011 Cequent Performance Products

Sheet 1 of 65057N 07-05-11 Rev. B

Qty. (4) Carriage Bolt, 1/2” -13 x 1 1/2” Gr5

Qty. (4) Block 1/4” x 1-1/2” x 2

Qty. (4) Conical Washer, 1/2”

Qty. (4) Hex Nut, 1/2”

Tighten all ½” fasteners with torque wrench to 75 Lb.-Ft.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Fastener Kit: 65057F

Form: F205 Rev A 5-6-05

9,000lb.

MAXIMUM WINCH LINE PULL

CARGO CAPACITY – Do not exceed

500 LB. or Truck Front

Gross Axle Weight Rating, (GAWR).

1. It is necessary to trim a section out of the plastic air dam attached to bottom of bumper. See Picture

above.

2. Locate and remove the18mm flange nuts on outside of truck frame rails, slide the bolt plate back into

frame but do not remove.

CAUTION: DO NOT completely remove bolt plate, if removed bumper will drop and may result in injury.

3. Raise hitch into position, slide bolts plates back thru frame and into hitch side brackets. Loosely install

nuts removed in Step 2.

4. Use 1/2” bolt leaders to pull 1/2” carriage bolts and spacer blocks thru the frame slots and through the

hitch as shown. Square shoulders of bolts must be pulled into blocks to engage with the sides of frame.

Check to see that carriage bolt is engaged in block holes. Install conical washers and hex nuts as

shown.

5. Tighten flange nuts and torque all hardware to the specs specified below.

CONSULT VEHICLE OWNER BEFORE TRIMMING OR CUTTING PLASTIC AIR DAM.

This is a magnified

view of a Bolt Leader

1 2

3 4

TRIM FACIA AS SHOWN

3 ½”

3/4”

Summary of Contents

Page 1 - Installation Instructions

Front Mounted Receiver Installation Instructions Dodge 2500 4x4 Models Part Numbers: 65057 Hitch Shown In Proper Position Equipment Required: Bolt lea

Comments to this Manuals

No comments

Draw-tite 65057 FRONT MOUNT RECEIVER User Manual

Browse online or download User Manual for For the car Draw-tite 65057 FRONT MOUNT RECEIVER. Draw-Tite 65057 FRONT MOUNT RECEIVER User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Draw-tite 65057 FRONT MOUNT RECEIVER