Draw-tite 65014 FRONT MOUNT RECEIVER User Manual download pdf

Frame Rail

Stabilizer Bar

Existing Weldnuts

Typical Both Sides

Recovery Eye

Stabilizer Bar

Brackets

Existing Bolts

Front Mounted Receiver

Installation Instructions

Ford F-250 HD 2WD & F-350

Diesel Engine Only

Part Numbers:

65014

1. Remove stabilizer bar fasteners and brackets allowing stabilizer bar to swing free.

2. Raise stabilizer bar, receiver and stabilizer bar brackets into position and install all fasteners as shown. Receiver side brackets

go between frame rails and stabilizer bar brackets.

Tighten all M8 CL9.8 fasteners with torque wrench to 20 Lb.-Ft (27 N-m).

Rev. A11-07-05N65014Sheet 1 of 3

z 2005 Cequent Towing Products

Hex Nut, 1/2”Qty. (4)

Spacer, 1” x 2” x 1/4”Qty. (4)

Conical Washer, 1/2”Qty. (4)

Carriage Bolt, 1/2”-13 x 1-3/4”Qty. (4)

Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Wrenches: 7/8”, 13mm

Equipment Required:

Drill Bits: None

Fastener Kit: K65014

Receiver Shown In Proper Position

Stabilizer Bar Stabilizer Bar Bracket

Frame Rail

Bumper

CARGO CAPACITY – DO NOT EXCEED

500 LB. OR VEHICLE FRONT GROSS

AXLE WEIGHT RATING. (GAWR)

LB. MAX. WINCH LINE PULL

9000

1 2 3

Summary of Contents

Page 1 - Installation Instructions

Frame RailStabilizer BarExisting WeldnutsTypical Both SidesRecovery EyeStabilizer BarBracketsExisting BoltsFront Mounted ReceiverInstallation Instruct

Page 2 - Instructions d’installation

Récepteur montré dans la position appropriéeLongeron de châssisBarre stabilisatriceÉcrous à souder existantssimilaires des deux côtésAnneau d’arrimage

Page 3 - Instrucciones de instalación

Larguero del bastidorBarra estabilizadoraTuercas para soldar existentesiguales en ambos costadosOjo de recuperaciónSoportes de la barra estabilizadora

Comments to this Manuals

No comments

Draw-tite 65014 FRONT MOUNT RECEIVER User Manual

Browse online or download User Manual for For the car Draw-tite 65014 FRONT MOUNT RECEIVER. Draw-Tite 65014 FRONT MOUNT RECEIVER User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Draw-tite 65014 FRONT MOUNT RECEIVER