Draw-tite 75146 MAX-FRAME RECEIVER User Manual download pdf

INSTALLATION

INSTRUCTIONS

Product No.

33003/75146

PLYMOUTH, MI

BUICK ROADMASTER,

CHEVROLET CAPRICE,

& CADILLAC FLEETWOOD

SMALL PARTS

PACKAGE 36364

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY

OCCUR DUE TO OVER TIGHTENING.

WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY SUPPLIED OR APPROVED BOLTS, LOCKNUTS, AND

WASHERS TO INSTALL THIS HITCH

(OVER)

TOOLS REQUIRED

15 mm WRENCH

15 mm SOCKET

3/4" SOCKET

9/16" DRILL

TORQUE WRENCH

1/2" SERRATED WASHER

1/2" NUT

EXISTING NUT

3/8" RIB NECK BOLT

1/2" CARRIAGE BOLT

BOLT PLATE

SMALL SPACER

5/16" SERRATED WASHER

M8 HEX BOLT

3/8" LOCK WASHER

3/8" NUT

NOTE: DO NOT LUBRICATE THREADS AS IT MAY CAUSE BOLT FAILURE DUE TO OVERTIGHTENING.

This receiver hitch is sized 2" square. Hitch bar must insert 5-3/4" minimum.

1. Remove four metric bolts (two per side) which fasten the Energy Absorbing cylinders to the frame. Save the nuts. Discard the

bolts.

CAUTION: BOLT PLATE LOCATION WITHIN THE FRAME IS CRITICAL. BOLT HOLES MUST BE LOCATED AND DRILLED

TO THESE INSTRUCTIONS TO INSURE SAFE FRAME LOADING. IMPROPER HOLE LOCATION WOULD RESULT IN

ATTACHMENT FAILURE. TRAILER SEPARATION FROM CAR COULD RESULT.

1/2" LOCK WASHER

1 2

Summary of Contents

Page 1 - PLYMOUTH, MI

INSTALLATIONINSTRUCTIONSProduct No.33003/75146PLYMOUTH, MIBUICK ROADMASTER, CHEVROLET CAPRICE,& CADILLAC FLEETWOODSMALL PARTS PACKAGE 36364WARNING

Page 2 - LIMITED WARRANTY

OUTSIDEFig. 2INSTALLING BOLT PLATE IN FRAMEINSIDE2. Scribe two lines, one on each frame bottom, .88" (7/8") from outside edge of frame and

Comments to this Manuals

No comments

Draw-tite 75146 MAX-FRAME RECEIVER User Manual

Browse online or download User Manual for For the car Draw-tite 75146 MAX-FRAME RECEIVER. Draw-Tite 75146 MAX-FRAME RECEIVER User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Draw-tite 75146 MAX-FRAME RECEIVER