Draw-tite 118261 OEM WIRING HARNESS User Manual download pdf

READ THIS FIRST:

Read and follow all vehicle warnings and

installation instructions before beginning installation.

Wear safety glasses and use all safety precautions

during installation.

LISEZ CECI EN PREMIER:

Lire et observer toutes les consignes de sécurité et les

instructions avant de commencer l’installation. Durant

l’installation, veiller à toujours porter des lunettes

de protection et respecter les mesures de sécurité.

LEA ESTO PRIMERO:

Lea y siga todas las advertencias e instrucciones

de instalación del vehículo antes de empezar la

instalación. Use gafas de seguridad y todas las

precauciones de seguridad durante la instalación.

118261-037 Rev. A 07/14/2010

Installation Instructions

Directives de Montage

Instrucciones de Instalación

T-Connector

Connecteur en T

Conector en T

ENGLISH

TOOLS REQUIRED:

Test-probe

1. Locate the vehicle’s wiring harness 16-Pin and

4-Pin plugs located in the rear, underneath the

vehicle, inside the driver’s side frame rail. This

harness will have connectors that will mate to the

end of the tow plugs.

NOTE

If only the 16-Pin housing is present, discontinue

installation. Consult application guide for the

Class I wiring harness.

2. Remove factory tow harness protective caps and

check to see if the mating surface is clean and

free of dirt, clean if necessary.

3. Insert the tow plugs into the connectors. Be

careful not to damage the locking tabs and be

sure that connectors are fully inserted with

locking tabs in place.

4. Open the vehicle’s hood and locate the fuse/

relay box on the Driver’s side near the ﬁrewall.

Consulting your owner’s manual, locate the

Trailer Tow Battery Charge Relay location and

insert the relay (provided).

5. Route the T-Connector harness along the inside

of bumper toward the center of vehicle.

WARNING

Route the wire being careful to avoid any hot

pipes, heat shields, the fuel tank or any other

points that may pinch or break the wire.

6. Plug the 7-way socket (provided) into the Trailer

Tow Harness.

WARNING

Secure all loose wires and mount the Trailer Tow

Harness in an accessible location with a bracket

or electrical box (not included).

WARNING

All connections must be complete for the

T-Connector to function properly. Test and

verify installation with a test light or trailer once

installed.

WARNING

Overloading circuit can cause ﬁres. DO NOT

exceed manufacturer’s fuse rating. Read vehicle’s

owners manual & instruction sheet for additional

information.

Ford E-150

1 2

FRANCAIS 2

Summary of Contents

Page 1

READ THIS FIRST:Read and follow all vehicle warnings and installation instructions before beginning installation. Wear safety glasses and use all saf

Page 2 - FRANCAIS

FRANCAISOUTILS REQUIS: Sonde de vériﬁcation1. Identiﬁez les prises à 4 broches et à 16 broches du faisceau de câblage du véhicule à l’arrière, s

Comments to this Manuals

No comments

Draw-tite 118261 OEM WIRING HARNESS User Manual

Browse online or download User Manual for For the car Draw-tite 118261 OEM WIRING HARNESS. Draw-Tite 118261 OEM WIRING HARNESS User Manual [es]

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Draw-tite 118261 OEM WIRING HARNESS